Setup 23xxx with Cadkey 6.01 for DOS and Windows

A.   The following are settings are for the DrawingBoard 2300 series digitizer and Cadkey 6.01:

      1.   To change menu settings, perform the following steps:

      a.   Place cursor on "Setup" box.
      b.   Pick the "0" button & the Power Light will come on.
      c.   Power Light  ON or OFF will indicate whether switch is ON or OFF. The Pick/0 button will toggle the light to the
            setting you wish.
      d.   When finished, EXIT by hitting the "Setup" box again.


B.   2300 configuration for the DOS driver:

      1.   Cadkey Using Summa MM Series 1201, if using a 4 button cursor.

            Mode      Parity    Baud Rate   Format       Data Rate
            00100     1000      001             00011        100

            Resolution      Freq
            100                1


C.   2300 configuration for both DOS and Windows:

      1.   Mouse drivers for DOS & Windows:

      Mode      Parity     Baud Rate   Format     Data Rate
      01000     1100       001             10000       111

      Resolution    Freq
      110              1

      SWITCH  KEY
      ---------------------
      1  =  LED is On
      0  =  LED is Off

      NOTE:   Make sure no mouse drivers are loaded when using Cadkey.

For Version DRVSET22:  To unload DBMOUSE use the RMDRV command from the CALDB directory, or add C:\CALDB\RMDRV to your Cadkey batch file.

For Wintab™ driver 2.2:  To unload CCMOUSE use the CCMOUSE /u command from the CALDB directory, or remove the CCMOUSE load line from the AUTOEXEC.BAT file.